← How to fuse ordinary hydrogen
✨ Fuel recovery
The graphite first wall, buffer vessel, and recycling of fusion products.
Catalyst recovery and fresh supply
The station imports hydrogen and carbon, recycles useful CNO and unburned hydrogen, and removes helium. It processes about 664.41 million kg/s of gross pulse fuel, including 52.451 million kg/s of returned hydrogen and 568.28 million kg/s of circulating CNO.
At the selected throughput, fresh hydrogen is about 44.464 million kg/s and fresh carbon about 14,985 kg/s, a carbon-to-hydrogen mass ratio of 0.0003370. Most of that carbon replaces catalyst converted into oxygen-16 outside the four-stage fuel cycle. The oxygen remains inside the station as a separate inventory. The 0.007 carbon-to-hydrogen resource budget is a ceiling, while initial construction material and circulating stock are separate inventories.
The first wall uses a 150 µm aligned graphite collection layer with a thin cap, buried channels and a sealed gas plenum. Mobile gas is collected continuously through short local paths. Targeted repair maintains the surface and seals during operation, while isolated periodic extraction handles more strongly trapped material. A separate sealed working-fluid circuit carries heat from the graphite to the engine.
Warm molecular pumps move recovered hydrogen and helium into an enclosed 1,000 K buffer vessel, then onward for separation. Hydrogen can be collected by getters; helium goes to isolated cold sorber banks that alternate between collection and regeneration. The buffer provides 0.5 m³ of volume per square metre of first wall and reaches about 0.34–2.07 Pa in the full-incident hydrogen and helium capacity calculation. That is a pressure inside the buffer, not the pressure of the central cavity.
At 2 MJ/kg input and the pulse schedule, renewing the entire 100 nm face after each pulse averages about 0.024 W/m². Processed graphite and trapped atoms return through the recovery system.
The cavity also receives reflected or released hydrogen and helium, carbon vapor, chemical products and dust. The pumping and collection system is intended to clear these materials between pulses.
See the sources and calculations for the full article.